You can find more information on the hyperion website: It took me 2 HDMI2AVI converters to get it right. If you cant get it right then replace your HDMI2AVI converter and in worst case your grabber. If it is to blury then you can adjust some settings. The image can never be 100 percent without some blury in it.
Now that the software is installed we need to configure it. It is possible that your system reboots now automatically! If you see no “Critical Error” message, all went good. Now be patient (installation may take up to 5 minutes).Īfterwards you see the script output.
NOTE: You could use this button also to UPDATE Hyperion to a newer version.Ħ. Or you login on your router and search their for the dhcp lists.ĥ. Now search for phrases like “openelec/osmc/raspberry” and type in that ip address listed there.
Target IP HINT: If you don´t know it, search it with Advanced IP-Scanner (Windows only) you don´t need to install it, just use “Execute” and then click the “Scan” button. If you have done your settings just click on “ Connect“.If all greyed out buttons on the HyperCon SSH tab below are enabled now, you are connected!
But then again I already start putting the ledstrips on the tv before I know about these corners. You can buy corners for APA102 LED Strip on Ebay or Ali but they did not work for me. It looks overwelming but trust me it is not that diffucult. Watch the tutorial from youtube first on this page so you have an idea what to expect.
This way I use the Pi at its full potential. It is slow with navigating but it plays the movies perfectly. I also put kodi on the raspberry pi zero. The tutorial was not very clear for me and some parts did not work.